The Shop > CNC
Cetus3D 3D Printer
PekkaNF:
How did that printer fare the odoyssey.
Pekka
awemawson:
Not opened the box yet Pekka - I'm going to do it forensically and slowly when I'm not rushed - just returned from Canterbury and have a few livestock issues to attend to, and first thing in the morning after feed time I need to get the Goliath Power Hammer loaded up onto transport that's arriving. When that's all calmed down (and I've calmed down !) I'll have at it :dremel:
awemawson:
OK this morning I took the plunge and unpacked the 3D printer to examine what if any damage has been done.
Ominously the gash in the box has penetrated the rigid foam packing and seems to have reached the end of the Z stepper motor assembly, but with any luck it's not done any damage other than perhaps skewed the alignment.
I won't know that until I'm in a position to power it up and try it out.
awemawson:
So I then carried on unpacking the whole assembly - over all I'm quite impressed with the packing - rigid foam cut and glued to shape holding everything in place, with a shipping clamp preventing movement of the axis's.
awemawson:
Photo's continued
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version