| The Shop > CNC |
| Cetus3D 3D Printer |
| << < (25/26) > >> |
| awemawson:
Then it was a case of churning them out, night and day. I even set a camera on them so I could monitor them printing remotely ! Because of the increased width I 'only' needed twelve, but in the event I actually printed fourteen as two didn't clean up as well as I wanted. 4 hours and 41 minutes each :bugeye: End result however is that two previously useless (to me) racks are now very handy, and for a very modest cost compared to buying the real things. |
| AdeV:
How many do you print in one sitting? Once I get my wardrobe slider things right, I'll go for printing all 7 (the first one that's right, I won't need to re-print of course :smart:) in one go - it's a 7 hour print right now, because of the height I think, for minimal overhangs, I've got them printing vertically. Not sure how much each extra item will add, but I'm hoping it's rather less than 7 hours... |
| awemawson:
Just the one at a time Ade. Two might just about squeeze in but the print time wouldn't be much less. |
| AdeV:
Crumbs - how big ARE they? It looks like you should easily be able to get 4 or even 6 on the bed at once... unless my sense of scale is completely out of kilter? |
| awemawson:
100 mm x 70 mm by about 65 tall For scale the hole in the middle is 42 mm (To take a VDI 40 spigot) The Cetus 3D table build size is 180 mm x 180 mm |
| Navigation |
| Message Index |
| Next page |
| Previous page |