The Shop > Our Shop

I Needed Some Collet Racks

<< < (5/6) > >>

awemawson:
Never mind - tweak the Autocad drawing, trim a bit off each side and make a bespoke set for the drawers. This does rather reduce the area for labelling, but I'm sure I'll get over that  :ddb:

Symon:
Love that level of ocd organisation :drool:

awemawson:
Believe me, with 0.25 mm increments so 80 of them, and some of the marking being very faint, they NEED to be organised  :clap:

spuddevans:
A very neat solution to the storage problem  :thumbup: :thumbup:

It's a pity your laser cutter couldn't be pressed into service to laser-etch the labels ( but then you'd have to make a 3rd set of collet holders to etch them before bending!!! )

Tim

awemawson:
Well Tim, I don't know if you recall the discussion we had here on the forum concerning marking steel with a Laser Engraver using 'Dry-Moly'

http://madmodder.net/index.php/topic,11174.msg135000.html#msg135000

I did consider marking the sizes boldly using that process, but it would take absolutely ages and this collet business is a distraction from an interruption from a diversion so common sense said STOP  :lol:

Navigation

[0] Message Index

[#] Next page

[*] Previous page