| The Shop > Our Shop |
| I Needed Some Collet Racks |
| << < (5/6) > >> |
| awemawson:
Never mind - tweak the Autocad drawing, trim a bit off each side and make a bespoke set for the drawers. This does rather reduce the area for labelling, but I'm sure I'll get over that :ddb: |
| Symon:
Love that level of ocd organisation :drool: |
| awemawson:
Believe me, with 0.25 mm increments so 80 of them, and some of the marking being very faint, they NEED to be organised :clap: |
| spuddevans:
A very neat solution to the storage problem :thumbup: :thumbup: It's a pity your laser cutter couldn't be pressed into service to laser-etch the labels ( but then you'd have to make a 3rd set of collet holders to etch them before bending!!! ) Tim |
| awemawson:
Well Tim, I don't know if you recall the discussion we had here on the forum concerning marking steel with a Laser Engraver using 'Dry-Moly' http://madmodder.net/index.php/topic,11174.msg135000.html#msg135000 I did consider marking the sizes boldly using that process, but it would take absolutely ages and this collet business is a distraction from an interruption from a diversion so common sense said STOP :lol: |
| Navigation |
| Message Index |
| Next page |
| Previous page |