| Home Base > Introductions |
| CNC nut from Texas |
| << < (3/3) |
| howsitwork?:
Hi Rob sorry you lost me on the technical stuff :bow:. I'm still getting to trust I pads etc ( actually starting to like em even to my amazement ) :scratch: welcome to the collective. Ian |
| Biggles:
Hi Rob and welcome. :wave: |
| AdeV:
Hey Rob, welcome! I think you'll like it here... Sounds like you & I got bit by the coding bug at about the same time... I guess I'd have been 10 years old the first time I even saw a computer (in 1983, that would be). I was lucky, I got to follow my ambition through senior school and on to college (well, Polytechnic, which is a kind of University-lite....). Spent the last 20-odd years writing software! Funnily enough, I prefer to do machining these days, and thoroughly enjoying using my CNC mill. Sure, it's ancient & uses an obsolete programming language, but it does for me. And I'll have to learn G-code anyway, when I get my Mazak lathe going... one day. Anyway, welcome to the mad modders! We're all mad here, but in the very best of ways :nrocks: |
| Doc:
Welcome Rob We have a similar problem with the original file (master model) being edited instead of being locked and a rev copy being edited. We use Siemens NX and Team Center to supposedly control it but some designers have found ways around releasing (locking) the master and creating a rev file. Saves them a few seconds only to cost use hours getting back to the master. We actually use 3 different design software Catia, NX and FeatureCam used in he tooling room. Anyway welcome aboard! |
| Navigation |
| Message Index |
| Previous page |