Gallery, Projects and General > How do I??
Injection molded fan
AdeV:
--- Quote from: Joules on April 07, 2017, 08:50:07 AM ---http://www.likecool.com/
--- End quote ---
Bugger, there went the rest of the day then!
Superb website, thanks for the link!
Joules:
These are a very useful set of videos to get an introduction to injection moulding.
John Rudd:
Had some success with molding!
Made a silicone mold from the original fan then cast a fan in the mold.....
Looks good, just need to machine the fan to size and balance it....
Joules:
Now that, does look like it turned out well. No problems with air trapped in the blade areas ?
John Rudd:
Joules,
No issues at all with any aspect.....In fact, the mold was so good at replicating the original fan, I could actually see the the part number....TPD6.....in both mold and new fan.....
I've since cleaned up the new casting and fitted it to the drill motor and it works a treat.... :beer:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version