| Gallery, Projects and General > How do I?? |
| Injection molded fan |
| << < (3/4) > >> |
| AdeV:
--- Quote from: Joules on April 07, 2017, 08:50:07 AM ---http://www.likecool.com/ --- End quote --- Bugger, there went the rest of the day then! Superb website, thanks for the link! |
| Joules:
These are a very useful set of videos to get an introduction to injection moulding. |
| John Rudd:
Had some success with molding! Made a silicone mold from the original fan then cast a fan in the mold..... Looks good, just need to machine the fan to size and balance it.... |
| Joules:
Now that, does look like it turned out well. No problems with air trapped in the blade areas ? |
| John Rudd:
Joules, No issues at all with any aspect.....In fact, the mold was so good at replicating the original fan, I could actually see the the part number....TPD6.....in both mold and new fan..... I've since cleaned up the new casting and fitted it to the drill motor and it works a treat.... :beer: |
| Navigation |
| Message Index |
| Next page |
| Previous page |