The Shop > Tools
I needed a BIG spanner !
RussellT:
Nice Job Andrew. :clap: :clap: :clap:
Did you think about a 12 point one?
Russell
shipto:
--- Quote from: awemawson on April 01, 2017, 02:19:43 PM ---
... very satisfying
(oh did I say - I LOVE my CNC Plasma Table !!!)
--- End quote ---
Rightly so its something we could probably make use of at work (I certainly could anyway :lol: but I suppose that would be too much like forward thinking for my place :Doh:)
Spurry:
Andrew, lovely job...again. :D
Can't help but think 6mm would have been kinder on the old fingers, although it's only a collet to tighten.
Pete
awemawson:
--- Quote from: RussellT on April 01, 2017, 02:43:55 PM ---Nice Job Andrew. :clap: :clap: :clap:
Did you think about a 12 point one?
Russell
--- End quote ---
Little point (sorry, unintentional pun!) Russell - the holder sits inverted in a 'CAT 40 receiver' in the bench vice for tightening, and the spanner never leaves the nut.
Oh and Pete, the 3 mm thick handle only gets a firm hand tweak, then is tapped tight with a nylon mallet, so my fingers don't really suffer !
mattinker:
Looks like a sort of giant mecano spanner!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version