| The Shop > Tools |
| I needed a BIG spanner ! |
| << < (2/4) > >> |
| RussellT:
Nice Job Andrew. :clap: :clap: :clap: Did you think about a 12 point one? Russell |
| shipto:
--- Quote from: awemawson on April 01, 2017, 02:19:43 PM --- ... very satisfying (oh did I say - I LOVE my CNC Plasma Table !!!) --- End quote --- Rightly so its something we could probably make use of at work (I certainly could anyway :lol: but I suppose that would be too much like forward thinking for my place :Doh:) |
| Spurry:
Andrew, lovely job...again. :D Can't help but think 6mm would have been kinder on the old fingers, although it's only a collet to tighten. Pete |
| awemawson:
--- Quote from: RussellT on April 01, 2017, 02:43:55 PM ---Nice Job Andrew. :clap: :clap: :clap: Did you think about a 12 point one? Russell --- End quote --- Little point (sorry, unintentional pun!) Russell - the holder sits inverted in a 'CAT 40 receiver' in the bench vice for tightening, and the spanner never leaves the nut. Oh and Pete, the 3 mm thick handle only gets a firm hand tweak, then is tapped tight with a nylon mallet, so my fingers don't really suffer ! |
| mattinker:
Looks like a sort of giant mecano spanner! |
| Navigation |
| Message Index |
| Next page |
| Previous page |