| The Breakroom > The Water Cooler |
| How to make really crappy 3D prints |
| (1/2) > >> |
| JayMcClellan:
I just saw this offer from banggood, looks like a fine way to make biodegradable items if you can stand the smell. Now I just need to find some #2 filament... :) |
| efrench:
Actually, the design of these hotends are so simple, the clones can actually work quite well. |
| JayMcClellan:
I don't doubt it, but I was amused specifically by the wording. Read carefully. |
| philf:
--- Quote from: JayMcClellan on March 24, 2017, 02:20:25 PM ---I don't doubt it, but I was amused specifically by the wording. Read carefully. --- End quote --- Re: How to make really crappy 3D prints. 0.4mm E3D-V6 Metal 3D Printer Exturder Nozzle. :thumbup: |
| PekkaNF:
Few spelling mistakes normally does not make any difference in any other sphere than sosial media. Spelling mistakes from chinese supplier hardly are "Unpresidented". Pekka |
| Navigation |
| Message Index |
| Next page |