Seeing all the superb projects on the go around here of late I'm almost embarrassed to post this
![:ddb:](https://madmodder.net/Smileys/default/dancenana.gif)
I'm in need of some T nuts for my mill, I didn't get very far tonight cos I've been doing other more taxing things. So I fancied winding down in the workshop doing something simple......well, that's my excuse.
Nothing much to show, I took a rough bar of unknown steel that Ralph kindly donated and ran the fly cutter over it a few times.
Nothing fancy, but the practice was good.
I started with small cuts and took it easy, as you can see I took a fair bit off the width. 0.05mm with each pass got tedious, even with power feed.
I ended up taking 0.5mm per pass at full wiper setting
![:)](https://madmodder.net/Smileys/default/side2side.gif)
It seemed pretty fast going to me, but the machine didn't complain at all even if it was a bit noisy.
Made a right mess of the workshop though this fly cutting, must make some sort of screen up.
![](http://i401.photobucket.com/albums/pp92/thebodger/Sealey%20Milller/T%20Nuts/IMG_2171.jpg)
![](http://i401.photobucket.com/albums/pp92/thebodger/Sealey%20Milller/T%20Nuts/IMG_2172.jpg)