Gallery, Projects and General > Project Logs
Another homemade milling machine
mexican jon:
I"m with John :scratch: on the run a bead of weld around the bearing shell and they just drop out :ddb:
Houtenkrullen:
--- Quote from: vintageandclassicrepairs on March 25, 2017, 05:36:34 PM ---Another option would be variable pulleys ala Daf variomatic ? also used on most modern mopeds
you would need to be able to control the movement of the pulleys rather than the centrifugal(?) mechanism used on them
--- End quote ---
If you are interested to use the moving pulleys idea, I am overhauling an old flott drill press that uses just that. I could send you a parts diagram and some pictures if they would be of any use for inspiration?
I am following your thread in awe...
I am not brave enough to start a machine build from scratch, but you seem to be doing just fine
Peter
shipto:
--- Quote from: Houtenkrullen on April 06, 2017, 06:03:18 AM ---
--- Quote from: vintageandclassicrepairs on March 25, 2017, 05:36:34 PM ---Another option would be variable pulleys ala Daf variomatic ? also used on most modern mopeds
you would need to be able to control the movement of the pulleys rather than the centrifugal(?) mechanism used on them
--- End quote ---
If you are interested to use the moving pulleys idea, I am overhauling an old flott drill press that uses just that. I could send you a parts diagram and some pictures if they would be of any use for inspiration?
I am following your thread in awe...
I am not brave enough to start a machine build from scratch, but you seem to be doing just fine
Peter
--- End quote ---
Thank you for the offer Peter but I have a inverter coming thanks to Mexican Jon and so the machine will at least in the first place will be directly driven.
As for building the machine I just kept bits for ages before starting then jumped in two footed, I have made mistakes even in the very little I have done so far wait till you see the latest one which I will take pics of tomorrow actually not tomorrow me and wife are going to see mrs browns boys so saturday its a real :doh:
shipto:
Well here in pic1 is the latest mistake It wasnt till I had welded the flang on, cleaned it up and centered each side that I set it up and did a cut along the length and I noticed it had been cut half way through :doh: cant even remember what I started to cut it for.
Well went back to my bits of steel and started again and pic 2 is the result. I am very pleased with it this is the first time I have cut a thread and made nuts to suit which is where I was at the end of today and apart from my parting tool of sorts breaking part way through meaning I had to finish it on the donkey saw even this went reasonably well.
I still have to clean up the nut and cut the lock nut off the bar which is the job for tomorrow.
hermetic:
Nice work Shipto!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version