The Shop > Tools
End Mill Sharpening, end and side.
Metalman:
To see my videos showing an end mill being sharpened using my grinding rests, visit this page for a link to them, http://www.homews.co.uk/page145.html Even if you do not have, or intend to make, one of my rests, you may find the videos of interest.
However, for an alternative method of sharpening end mills, visit this page for a link to another video. http://www.homews.co.uk/page121.html
Harold
sparky961:
I'm sure that many of these links are of use to people, but if you aren't going to partake in a discussion about them isn't it just advertising?
awemawson:
Harold Hall is posting these links across a wide spectrum of forums.
Let us give him the opportunity to respond to the above comment and judge by his response if any :scratch:
ieezitin:
I like the fact he is promoting his stuff.. I have a couple of his books a worth while read.. learned a couple of things along the way, knowledge is power it also aint cheap..I have no problem with Harold getting out his word.... Anthony.
sparky961:
--- Quote from: ieezitin on February 26, 2017, 06:30:48 PM ---I like the fact he is promoting his stuff.. I have a couple of his books a worth while read.. learned a couple of things along the way, knowledge is power it also aint cheap..I have no problem with Harold getting out his word.... Anthony.
--- End quote ---
I don't have any problem with the promotion itself. I just don't think that a forum is the place for a one-way "discussion". Especially when it is commercially motivated.
Navigation
[0] Message Index
[#] Next page
Go to full version