The Shop > Tools
Edgwick Lathe
mattinker:
10mm That's enormous, I had 0.6mm at worst!
are the test bars being held by the full length of the Jaw?
It sounds like your a couple of decimal points out!
Cheers, Matthew
PekkaNF:
Reminds me of my "Clumsy bastard" error: I was schoked to find that my finishing touch of balancing fixture shaft increased the excentricity 5 fold, then I noticed that I used 0,002 mm/div indicator insted of the 0,01 mm/div indicator that I had used originally. Phew!
Pekka
HalifaxHerbert:
hi AWEMAWSON
The jaws are in their correct positions and have also been rotated .
HalifaxHerbert:
Gentlemen,
Please accept my sincere apologies.
0.010" run out and +/- 0.0025 run out.
Typographical error. :doh:
awemawson:
... that's better :clap: :clap: :clap:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version