| The Shop > Tools |
| Edgwick Lathe |
| << < (11/13) > >> |
| mattinker:
10mm That's enormous, I had 0.6mm at worst! are the test bars being held by the full length of the Jaw? It sounds like your a couple of decimal points out! Cheers, Matthew |
| PekkaNF:
Reminds me of my "Clumsy bastard" error: I was schoked to find that my finishing touch of balancing fixture shaft increased the excentricity 5 fold, then I noticed that I used 0,002 mm/div indicator insted of the 0,01 mm/div indicator that I had used originally. Phew! Pekka |
| HalifaxHerbert:
hi AWEMAWSON The jaws are in their correct positions and have also been rotated . |
| HalifaxHerbert:
Gentlemen, Please accept my sincere apologies. 0.010" run out and +/- 0.0025 run out. Typographical error. :doh: |
| awemawson:
... that's better :clap: :clap: :clap: |
| Navigation |
| Message Index |
| Next page |
| Previous page |