The Shop > CNC
About to give up
Will_D:
Re. my Arduino: Not sure if its a R3 Version.
Newer R3's don't have the big (!!) reset button. So may have to get a new one.
David Jupp:
Not sure if this helps - I pulled your nc file into NCPlot. That suggests the code is OK, the plot of the path looks fine.
j1312v:
Hi,
just for curiosity, is that the first G01? if so you may need to specify the feed.
Best,
J
AdeV:
--- Quote from: j1312v on January 25, 2017, 04:25:13 AM ---Hi,
just for curiosity, is that the first G01? if so you may need to specify the feed.
Best,
J
--- End quote ---
It's the second G01 command; maybe the first one is hanging due to needing a feed rate?
Also, doesn't the spindle speed need to be set somewhere?
j1312v:
Just downloaded the program and you probably you need to put the feed rate, otherwise the controller doesn't know what to do.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version