| The Shop > CNC |
| About to give up |
| << < (2/5) > >> |
| Will_D:
Re. my Arduino: Not sure if its a R3 Version. Newer R3's don't have the big (!!) reset button. So may have to get a new one. |
| David Jupp:
Not sure if this helps - I pulled your nc file into NCPlot. That suggests the code is OK, the plot of the path looks fine. |
| j1312v:
Hi, just for curiosity, is that the first G01? if so you may need to specify the feed. Best, J |
| AdeV:
--- Quote from: j1312v on January 25, 2017, 04:25:13 AM ---Hi, just for curiosity, is that the first G01? if so you may need to specify the feed. Best, J --- End quote --- It's the second G01 command; maybe the first one is hanging due to needing a feed rate? Also, doesn't the spindle speed need to be set somewhere? |
| j1312v:
Just downloaded the program and you probably you need to put the feed rate, otherwise the controller doesn't know what to do. |
| Navigation |
| Message Index |
| Next page |
| Previous page |