The Shop > CNC

My desktop CNC router's first cuts

<< < (2/3) > >>

NeoTech:
If i rememer correctly those machines were called "lillasyster" mening "Little sister" - where quite popular on the other forum and one of the earliest home built cnc machines i can actually remember. =)

MadModder:
Yes, you are absolutely right, my fellow moderator. ;)
The project threads for them were still quite active when you registered there back in '08.

Biggles:
The construction drawings or supplier and the electronics would be helpful in reconstructing a duplicate.  :dremel:

MadModder:
Well, as I implied by the "RIP", the supplier has gone west, faded away, and assumed room temperature.
Nobody has taken over. I believe a nephew of his helped with the cleaning of the house and has all the equipment in possession, but nobody has heard anything from him ever since. So, I guess the information is lost.
I don't have the mechanical drawings.
I don't have the schematics for the motor drivers (plug-in modules)
This will be so much fun the day the magic smoke lets itself out...

I do have the schematic for the break out board though, that the motor driver modules mount onto. I just have to convert it from Orcad to Altium. It may work well, i hope...  :scratch:

Biggles:
OK Modder, hope it doesnt also go west.  :Doh:

Navigation

[0] Message Index

[#] Next page

[*] Previous page