Gallery, Projects and General > Project Logs

Vice speed? handle

(1/4) > >>

Spurry:
Saw a glance of one of these on a Youtube video, a three-lever vice handle, and thought it would be interesting to make.

Having made the square hole for the vice shaft by using the lathe as a shaper, next job was the angled section. Not sure if everyone knows the dodge of a power top slide.

I replaced the small countersunk-head allen bolt, with a full-headed one. Chopped the end off a ball drive hex key and popped it in the drill.
This makes it a doddle to get a consistent speed across the whole of the angle, made more awkward with the top-slide handle being at the rear.

Pete

millwright:
Must admit Pete i hadnt thought of that one, nicely filed away for future reference.

John

graham:
Bet it dont reverse though :lol:

Spurry:

--- Quote from: graham on November 22, 2016, 03:53:59 PM ---Bet it dont reverse though :lol:

--- End quote ---
Funny you should say that....but it does.  :wave:
pete

graham:
Good, i thought it would unscrew it  :clap:

Navigation

[0] Message Index

[#] Next page