| Gallery, Projects and General > Project Logs |
| Vice speed? handle |
| (1/4) > >> |
| Spurry:
Saw a glance of one of these on a Youtube video, a three-lever vice handle, and thought it would be interesting to make. Having made the square hole for the vice shaft by using the lathe as a shaper, next job was the angled section. Not sure if everyone knows the dodge of a power top slide. I replaced the small countersunk-head allen bolt, with a full-headed one. Chopped the end off a ball drive hex key and popped it in the drill. This makes it a doddle to get a consistent speed across the whole of the angle, made more awkward with the top-slide handle being at the rear. Pete |
| millwright:
Must admit Pete i hadnt thought of that one, nicely filed away for future reference. John |
| graham:
Bet it dont reverse though :lol: |
| Spurry:
--- Quote from: graham on November 22, 2016, 03:53:59 PM ---Bet it dont reverse though :lol: --- End quote --- Funny you should say that....but it does. :wave: pete |
| graham:
Good, i thought it would unscrew it :clap: |
| Navigation |
| Message Index |
| Next page |