Gallery, Projects and General > How to's

Edgwick lathe cross-slide nut replacement

<< < (3/3)

CraigLie:
Hi AdeV,

You can add one more Edgwick owner in the US.

mattinker:
So, now we are five! Welcome!!

Regards, Matthew.

CraigLie:
Thank you, Matthew


chrisnaborg, I believe I encountered the same problem or similar problem.  I ended up stripping everything down cleaning it all up and reassembling.  Once I realized that the feed gearbox had some bad bearings. I ended up replacing all the bearings in the gearbox.  At that time I removed the apron clean examined and noted all that needs to be repaired or replaced, saving that job for a later project. then I removed/ disassembled the tool posts compound and cross slide thoroughly cleaned and reassemble them backed the way came apart.

Navigation

[0] Message Index

[*] Previous page