| Gallery, Projects and General > How to's |
| Edgwick lathe cross-slide nut replacement |
| << < (3/3) |
| CraigLie:
Hi AdeV, You can add one more Edgwick owner in the US. |
| mattinker:
So, now we are five! Welcome!! Regards, Matthew. |
| CraigLie:
Thank you, Matthew chrisnaborg, I believe I encountered the same problem or similar problem. I ended up stripping everything down cleaning it all up and reassembling. Once I realized that the feed gearbox had some bad bearings. I ended up replacing all the bearings in the gearbox. At that time I removed the apron clean examined and noted all that needs to be repaired or replaced, saving that job for a later project. then I removed/ disassembled the tool posts compound and cross slide thoroughly cleaned and reassemble them backed the way came apart. |
| Navigation |
| Message Index |
| Previous page |