Gallery, Projects and General > Project Logs
626 mill riser block
Spurry:
Looking good John. Well done. :thumbup:
Pete
Pete W.:
Hi there, John,
I'm pleased you were able to find a salvage scheme. :clap: :clap: :clap:
John Rudd:
:proj:
After another full days graft at it....here it is all finished with a coat of paint....
I couldn't get an exact match....so went for what I thought was closest...
Doesnt look too bad, better than leaving it 'naked' to have the elements attack it....
Overall I have around 420mm (16") between spindle and table with Z wound down....
John Stevenson:
John,
Out of interest what was the spigot dimension on yours, read back thru but didn't spot it.
John Rudd:
--- Quote from: John Stevenson on November 24, 2016, 10:41:24 AM ---John,
Out of interest what was the spigot dimension on yours, read back thru but didn't spot it.
--- End quote ---
John,
I made it 3.307 inches, or probably 84mm. i think there may be room for skimming another couple of thou off...now its all mounted it feels a bit tight...
The pcd for the bolts is 116 mm....I determined that from various measurments but to confirm it, made a cardboard template to fit over the machines spigot after adding a film of grease and pressing against the face....if you know what I mean....
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version