| Gallery, Projects and General > Project Logs |
| 626 mill riser block |
| << < (14/15) > >> |
| Spurry:
Looking good John. Well done. :thumbup: Pete |
| Pete W.:
Hi there, John, I'm pleased you were able to find a salvage scheme. :clap: :clap: :clap: |
| John Rudd:
:proj: After another full days graft at it....here it is all finished with a coat of paint.... I couldn't get an exact match....so went for what I thought was closest... Doesnt look too bad, better than leaving it 'naked' to have the elements attack it.... Overall I have around 420mm (16") between spindle and table with Z wound down.... |
| John Stevenson:
John, Out of interest what was the spigot dimension on yours, read back thru but didn't spot it. |
| John Rudd:
--- Quote from: John Stevenson on November 24, 2016, 10:41:24 AM ---John, Out of interest what was the spigot dimension on yours, read back thru but didn't spot it. --- End quote --- John, I made it 3.307 inches, or probably 84mm. i think there may be room for skimming another couple of thou off...now its all mounted it feels a bit tight... The pcd for the bolts is 116 mm....I determined that from various measurments but to confirm it, made a cardboard template to fit over the machines spigot after adding a film of grease and pressing against the face....if you know what I mean.... |
| Navigation |
| Message Index |
| Next page |
| Previous page |