Gallery, Projects and General > Project Logs
Engine swap - Snowblower
PekkaNF:
Snow is a good motivator. We got about 15 cm of it for two weeks and -16C (pretty cold - unseasonally). Now it has been raining and +6 for four days, snow is memory and because we have only few hours of daylight all looks pretty dark. I would take the snow.
Pekka
Brass_Machine:
Update...
I have almost all of the parts made. I need one more piece as bracing for the chute pivot mount. I ordered a bunch of hardware to assemble it. Should be here tomorrow. I also ordered new shear pins for the auger and ordered some rubber "paddles" for the impeller. <-- more on that later.
I also cleaned up the parts I made. I don't have any pictures today... Phone died ad it is getting late. I will try to get some up tomorrow!
Eric
Divided he ad:
:worthless:
:lol:
Getting there chief :thumbup:
RobWilson:
Tis looking very festive over there Eric :palm:
You better get your finger out :poke:
Rob
Brass_Machine:
I get it! Pictures inbound!
Collections of parts for the gear reduction and pivot mount for the chute.
Starting to mount things up
Ready to go. Almost...
Before anyone says it... Yes, I know, my shop is a total disaster. That is a winter project. Cleaning and organizing!
So, the back part is almost ready to go. I need to mount the handles and adjust the drive. Then it is on to the front (were it eats the snow). I want to clean it up, do a little work and mount some rubber paddles on the impeller.
So... more pictures later.
Eric
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version