Threaded spindle reverse

Gallery, Projects and General > How do I??

<< < (2/3) > >>

ieezitin:
Pete..

you forgot to mention after slamming it on insert the key into the hole and muller it a tad more with a lead hammer... :loco:

Jon...

I see how it would work I just aint got the goolies to hack a flat on my spindle.

Philf..

You may have something there... :coffee: in fact i am making a collet chuck and the back plate so on said back plate i could incorporate the slot..ummmm thanks

Anthony..

Pete.:

--- Quote from: ieezitin on October 20, 2016, 05:59:12 PM ---Pete..

you forgot to mention after slamming it on insert the key into the hole and muller it a tad more with a lead hammer... :loco:

--- End quote ---

Also didn't mention how you were ever going to get it off again but that wasn't part of the brief :D

Glad you didn't take my advice seriously :thumbup:

chipenter:
The club has a lathe once belonged to a toolmaker , all three backplates have a grub screw that go into a dimple in the register , he must have made a matching fixture to drill all three the same .

Manxmodder:

--- Quote from: Pete. on October 21, 2016, 01:15:21 AM ---
--- Quote from: ieezitin on October 20, 2016, 05:59:12 PM ---Pete..

you forgot to mention after slamming it on insert the key into the hole and muller it a tad more with a lead hammer... :loco:

--- End quote ---

Also didn't mention how you were ever going to get it off again but that wasn't part of the brief :D

Glad you didn't take my advice seriously :thumbup:

--- End quote ---

Getting it off again is easy if you put a metre long bar through the space between the chuck jaws and give the end of the bar a good belt with a sledge hammer :lol:

Can't do any harm,It's only an old lathe :doh: .... OZ.

jcs0001:
Anthony:

My lathe (King 10X22 - very similar to the Grizzly G0602) has two L shaped pieces that are bolted to the chuck and fit into a groove on the outside of the spindle:

Shown without the bolt - I don't usually have them attached.

Shown without the L shaped holder and bolt - I put a thin rod in the screw hole just for emphasis:

Might be a bit difficult to make it the same as this but also may give you and idea or two.

John.

Navigation

 Message Index

Go to full version