Gallery, Projects and General > Gallery
topslide setting
Jonfb64:
Me too :mmr:
DavidA:
Wheeltapper,
You first posted this on the 28th September. Since then 169 people have viewed it.
As today is the 29th September, I don't think you have done too badly for interest.
Don't get disheartened if people are slow responding.
Dave.
Lew_Merrick_PE:
Wheeltapper (and all),
OK, this has been a pretty busy month for me with 4 "concurrent" design projects on the table. This is the first that this thread garnered my attention. [The Tralfalmagorians have been holding me captive.]
I often have to make cuts that are within .001 runout to a given angle. The attached PDF shows the approach I came up with many years ago. Hopefully, this will give you some ideas to improve your set-up.
mfletch:
Good idea and works thanks for sharing
wheeltapper:
--- Quote from: DavidA on September 29, 2016, 10:24:38 AM --- Wheeltapper,
You first posted this on the 28th September. Since then 169 people have viewed it.
As today is the 29th September, I don't think you have done too badly for interest.
Don't get disheartened if people are slow responding.
Dave.
--- End quote ---
Don't get me wrong, I'm not going to sit in a corner and sulk :lol:
I just thought it had died.
Roy.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version