| Gallery, Projects and General > Gallery |
| topslide setting |
| << < (2/4) > >> |
| Jonfb64:
Me too :mmr: |
| DavidA:
Wheeltapper, You first posted this on the 28th September. Since then 169 people have viewed it. As today is the 29th September, I don't think you have done too badly for interest. Don't get disheartened if people are slow responding. Dave. |
| Lew_Merrick_PE:
Wheeltapper (and all), OK, this has been a pretty busy month for me with 4 "concurrent" design projects on the table. This is the first that this thread garnered my attention. [The Tralfalmagorians have been holding me captive.] I often have to make cuts that are within .001 runout to a given angle. The attached PDF shows the approach I came up with many years ago. Hopefully, this will give you some ideas to improve your set-up. |
| mfletch:
Good idea and works thanks for sharing |
| wheeltapper:
--- Quote from: DavidA on September 29, 2016, 10:24:38 AM --- Wheeltapper, You first posted this on the 28th September. Since then 169 people have viewed it. As today is the 29th September, I don't think you have done too badly for interest. Don't get disheartened if people are slow responding. Dave. --- End quote --- Don't get me wrong, I'm not going to sit in a corner and sulk :lol: I just thought it had died. Roy. |
| Navigation |
| Message Index |
| Next page |
| Previous page |