The Craftmans Shop > New from Old

Another flail mower thread

(1/3) > >>

smiffy:
This was dropped of this week by   a local farmer asking if I could weld it up and make it round  :bang:

awemawson:
Hi Smiffy,

Is (was!) that peg a support for a rear roller  :scratch:

smiffy:
Yes should have said that in the post ,its off a 8 foot cut flail mower .
The other end is as bad, plus the bearings are retained by circlips which are missing  and someone in the past has tack welded the bearings into the roller    :bang: so all in all a right mess

wgw:
Just the usual maintenance schedule for farmers. My advice would be to go on a long holiday.

micktoon:
By god Smiffy that is in see state, you must be keen, it looks like its been sculpted out of wet clay like a potters art piece.
  It's a good job farmers do not have control of aircraft maintenance eh  :bugeye:
  Cheers Mick

Navigation

[0] Message Index

[#] Next page