| The Craftmans Shop > New from Old |
| Another flail mower thread |
| (1/3) > >> |
| smiffy:
This was dropped of this week by a local farmer asking if I could weld it up and make it round :bang: |
| awemawson:
Hi Smiffy, Is (was!) that peg a support for a rear roller :scratch: |
| smiffy:
Yes should have said that in the post ,its off a 8 foot cut flail mower . The other end is as bad, plus the bearings are retained by circlips which are missing and someone in the past has tack welded the bearings into the roller :bang: so all in all a right mess |
| wgw:
Just the usual maintenance schedule for farmers. My advice would be to go on a long holiday. |
| micktoon:
By god Smiffy that is in see state, you must be keen, it looks like its been sculpted out of wet clay like a potters art piece. It's a good job farmers do not have control of aircraft maintenance eh :bugeye: Cheers Mick |
| Navigation |
| Message Index |
| Next page |