| The Breakroom > The Water Cooler |
| Need electricary help |
| (1/2) > >> |
| kayzed1:
Belle minigen 2000, i was using it ( well the lad was ) 1500w 4" grinder he has used with the genny hundreds of times and is well below max output. Engine revved up and stopped producing volts, it was set to 240v at the time it now does not produce power in either 110 or 240volt settings. I have taken the cover off and see it has a capacitor and not a regulator, the cap looks ok ( not puffed up or black or burst open ) so how do i test it please? Ow! the 240 outlet melted ( socket ) i have fitted a new one ready to test. Any help would be much appreciated. Lyn. |
| inthesticks:
I'm not familiar with a Belle minigen 2000 or European power for that matter but if the grinder is still ok then you may have grounded out at the socket. In any case you didn't mention it but there must be a fuse or breaker somewhere in the circuit. It would need replacing or resetting. Not much help but its a start. Cheers CB P.S. I feel you should use extreme care on ALL live electrical testing. These instructions were taken from a training textbook but if you feel they are not safe I will remove them. |
| DMIOM:
Lyn, Please be VERY careful if you follow those instructions above - you might get away with it on 110v but you could easily kill yourself with 240v :zap: Dave |
| John Rudd:
Just replace the capacitor, only sure fire way of ruling out failure.... Just make sure the replacement is Mains rated as a minimum! Self excited generators can produce voltages in excess of 240v if not regulated/governed properly.... |
| kayzed1:
Thanks for the replies chaps, i will get a new cap// So, how do they work then? as said no reg in it just the cap so how does it give a ( clean ) -ish 110 and 240v. It just has a switch, one way 110 the other way gives 240v.. Is there a way to check it out other than changing the Cap i mean, or even after changing it, the winding has four wires three colours and a black. Lyn. PS: the grinder is ok as it has been used on the mains 240v. |
| Navigation |
| Message Index |
| Next page |