Gallery, Projects and General > Gallery

Dual Brazing Fixture Light Welding Positioner

<< < (3/3)

inthesticks:
Yea I had a semi-chopped 450 Honda twin that I toured the States and northern Mexico on when I was much younger I prefer workshop work now. So what are you building that required an expensive frame builders trade jig?

Cheers
CB

tom osselton:
Well right now I'm building a vacumformer for Protospace a maker comunity I belong to, I found it to be  a interesting build and a bit chalenging trying to get the slide to slide properly as the lifting action is on the outide causing it to twist and bind then again it's aluminum on aluminum which doesn't help I've a couple ideas so I'll see today with any luck I'll drop it off tonight.

inthesticks:
Hey Tom, You should document and post it A good boost to your post #"s with a project like that. I would be interested, I have a couple DIY books on the subject. Those frames are steel not aluminum though. I'm assuming the form the base assembly.  :)

Cheers
CB

Navigation

[0] Message Index

[*] Previous page