The Craftmans Shop > New from Old
Carbide tool holder
chipenter:
The numbers if any on the side of the tool will give the type and size inserts used , it looks to have a forward slope so a negative insert in neaded ,
tom osselton:
I ordered 6 screws from Busy Bee to replace one that rounded the hex it took a good two months to get them!
mechman48:
--- Quote from: Manxmodder on September 08, 2016, 06:15:04 AM ---
--- Quote from: chipenter on September 08, 2016, 01:59:33 AM ---Is that a cutting incert or the anvill ? I have never seen a TN incert with a flat top like that before .
--- End quote ---
It does indeed look very much like there is no actual cutting insert and just the shim/anvil present in the photo....OZ.
--- End quote ---
As I see it you are definitely cutting with the carbide anvil; there should be an insert in there that would bring it level with the top of the holder.
George.
Navigation
[0] Message Index
[*] Previous page
Go to full version