| The Craftmans Shop > New from Old |
| Carbide tool holder |
| << < (4/4) |
| chipenter:
The numbers if any on the side of the tool will give the type and size inserts used , it looks to have a forward slope so a negative insert in neaded , |
| tom osselton:
I ordered 6 screws from Busy Bee to replace one that rounded the hex it took a good two months to get them! |
| mechman48:
--- Quote from: Manxmodder on September 08, 2016, 06:15:04 AM --- --- Quote from: chipenter on September 08, 2016, 01:59:33 AM ---Is that a cutting incert or the anvill ? I have never seen a TN incert with a flat top like that before . --- End quote --- It does indeed look very much like there is no actual cutting insert and just the shim/anvil present in the photo....OZ. --- End quote --- As I see it you are definitely cutting with the carbide anvil; there should be an insert in there that would bring it level with the top of the holder. George. |
| Navigation |
| Message Index |
| Previous page |