The Shop > Our Shop
A Home DIY'ers Shop Tour
inthesticks:
Hey Will the term "man cave" is getting a little dated I think.
FAR to tidy? Look back about 12 pictures, its ok in the middle of a project but would drive me round the bend on a regular basis.You guys playing with 3D can handle 3 dimensional workshops, 2 dimensions looks like as much as I can manage.
Cheers CB :)
tom osselton:
Here is my furnace build nothing fancy just a beer keg. I did have the base for a steam cleaner I wanted to make into a tipping / dipping furnace but my son dragged it into the alley and it was nicked by the scrap guy that cruises the alleys.
http://madmodder.net/index.php/topic,8920.msg97430.html#msg97430
I have a dust extractor I could use or a fume extractor for a 5 bay shop I picked up with motor for $50.00 that could be geared down my garage is only 24' x 28' so it wouldn't take to long to expell the air before drawing in the -20 c.
Id like to have a overhead heater instead of the floor type and possibly one of these Buddy wants $400.00 each but would make tempering easier.
Break and enter are on the rise in some areas and you can see more vehicles with a busted out window, a buddy I know had his broken out for a cigarette on the console! We will see what happens when their unemployment insurance runs out!
inthesticks:
Good build Tom, checked out a few guess I didn't go back far enough. For running furnace indoors positive venting is a must but you don't need to turn the whole shop into the outdoors, a negative press. damper placed near by with a snug sliding door to seal it of when not in use works great and will save you some energy.
Did you get the engine done?
My neighbor down the road takes care of security for me, he likes to sit in his rocking chair on his porch with a 12 gauge across his lap till the wee hours of the morning.Not really :) thats actually me. Not really :lol: :lol:
Cheers CB
RobWilson:
Hi CB
Cracking workshop :bow: , very well equipped :dremel: . Whats the "C" frame machine in the Grass seed photo ?
Cheers Rob
inthesticks:
Hey Rob, that is a pneumatic C frame punch press. It will do sheet metal punching and light stamping. I got it badly rusted and seized up. Rebuilt it last winter, top guide/pressure plate badly worn and most of the seals shot. Reground press. plate and added a shim on the back side to make up the difference, replaced all the seals and a good cleaning. Now runs great but I have yet to make tooling for it. This is one exception I have allowed E-Bay lately but even there I have not found tooling for this unit.
Cheers CB
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version