Gallery, Projects and General > Gallery
Myford Bed Wiper 3D Printed
Joules:
If your bed measures around these values ±0.1mm it should be OK.
The price would be (depends where on the planet you are) Don't forget this replaces the felt and metal cover and is for the Myford Super 7
The other point, I only just made this tonight it hasn't been properly tested, probably better than no felt, time will tell.
chipenter:
Poundland do felt for putting on the bottom of stuff to stop scatches , it's 3mm thick self adhesive two peices are 100 X 25 the rest are round , I have these on my south bend oil the from the top , and cleans and oils the vees .
Joules:
LOL undercut by Poundland :lol:
PK:
So just print them with a pocket to clamp some felt.
I did these on a laser but it's the same principle.
ps, NEVER laser cut felt!
PekkaNF:
--- Quote from: PK on August 22, 2016, 06:34:08 PM ---.....
ps, NEVER laser cut felt!
--- End quote ---
How did you found out that?
Pekka
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version