| Gallery, Projects and General > Project Logs |
| Wilson's Workshop Waffle |
| << < (20/74) > >> |
| RobWilson:
--- Quote from: Will_D on October 06, 2016, 06:57:27 PM ---Love that the "MAX RPM" is unspecified! A bit like "Max Headroom" --- End quote --- :lol: aye it is a bit random Will ,especially as its a fixed speed motor :scratch: Rob |
| RobWilson:
Afternoon Lads Well I picked up a couple more incidentals for the shop this morning , I had a wee run South to Pontefract and came back with these :drool: A rather tidy 10" Elliott rotary table for the Bridgeport . and an Auto reversing tapping head for the Arborga drilling machine Rob :dremel: |
| awemawson:
Did you win the lottery then Rob :scratch: |
| RobWilson:
--- Quote from: awemawson on October 08, 2016, 09:34:32 AM ---Did you win the lottery then Rob :scratch: --- End quote --- Nope just good at hunting out a bargain ,,,,,,,,,,or three Andrew :) Rob |
| RobWilson:
Evening Lads A wee bit product review :dremel: I had a job on today that required the relocation of a couple of holes in a hydraulic pump flange and a bracket , pump needed to be rotated about 10 degrees so that the suction hose would not foul the engine sump . The pump is located in a fairly confined space , so I cracked out the transfer screws I purchased wile at Arceurotrade a few weeks back . The kits come in two ranges 3mm - 6mm & 6mm - 12mm The M8 and M12 saved the day :thumbup: . Each kits come with a driver to fit and remove the transfer screws . Just the job :dremel: Rob http://www.arceurotrade.co.uk/Catalogue/Measurement/Punches-Scribes/Transfer-Screws |
| Navigation |
| Message Index |
| Next page |
| Previous page |