Gallery, Projects and General > Project Logs
Wilson's Workshop Waffle
RobWilson:
You sure its not you just being a Yorkshire man John :D
How much for a new one ? £1600 :bugeye: and it will need fixing from new :lol: :lol:
Rob
John Rudd:
A new one from Chester is £1635 or Warco £1640....
The operating envelope doesnt appear to be as good as the Eagle, but then its biggest advantage is the knee....and the table is a little smaller....
What repairs do you refer to?
The nice to haves I'd like are a 4" riser and a vfd conversion...
RobWilson:
--- Quote from: John Rudd on September 25, 2016, 09:31:23 AM ---
What repairs do you refer to?
--- End quote ---
Well mine was a real dog , lets just say the parts fit where they touched :palm:
Build quality , whats that !
Rare earth metals used lol
not one leadscrew is the same diameter
MMM there idea of a machined flat surface is not quite the same as mine
and getting two surfaces parallel ,,,,,,,,,,,,,,you must be joking .
And I could go on :Doh:
Rob
John Rudd:
Hmmm....Looks like you got your work cut out sorting stuff then.... :dremel:
Think I might look for something else.... :scratch:
Joules:
Hmmmmm, I had my heart set on a Warco 626 for years, but if I'm going to buy a project.... :scratch: Might as well be any of the available mills these days.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version