| Gallery, Projects and General > Project Logs |
| Wilson's Workshop Waffle |
| << < (70/74) > >> |
| awemawson:
Hey Rob, that's a brilliant dark corner to keep it - how lucky it just fits AND there's a handy power point :lol: :lol: ( just in case you wondered :poke: ) |
| RobWilson:
--- Quote from: Biggles on February 12, 2017, 11:39:02 AM --- in my case I have just ordered some angle for a gallows frame on the wall. Unlike your setup I am still with Andrew’s idea of a ring main. --- End quote --- Remember to take a few photos Biggles :poke: , we likes photos we do :thumbup: Rob |
| BillTodd:
Watch out for swarf finding its way down the spindle and dropping out down towards your RPC motor Rob. Might want to bung it up or direct it away to some where safer. Bill |
| RobWilson:
--- Quote from: BillTodd on February 12, 2017, 02:53:08 PM ---Watch out for swarf finding its way down the spindle and dropping out down towards your RPC motor Rob. Might want to bung it up or direct it away to some where safer. Bill --- End quote --- Was planning on fitting a spindle bung if needed Bill :thumbup: , And I plan to add a few remote stop/start switches around the shop, so I don't have to keep walking back and forth to switch the phase converter on and off. :zap: Rob |
| Mayhem:
Looking good Rob. I'm still plugging away with my shop. I clean up one section and then end up piling it full of crap out of the next one on my list :bang: I spent the whole of today sorting out fasteners. Funnily enough, the path to the beer fridge is nice and uncluttered :beer: |
| Navigation |
| Message Index |
| Next page |
| Previous page |