| Gallery, Projects and General > Project Logs |
| Wilson's Workshop Waffle |
| << < (68/74) > >> |
| SwarfnStuff:
Yup good stuff, That last pic shows the correct test procedure for any new bench top Rob. :coffee: I reckon the cuppa was well earned. I always like your posts. John B |
| Will_D:
--- Quote from: RobWilson on February 03, 2017, 04:45:22 PM --- I nipped across to Ikea today and picked up a Billy phase converter doodad, the kit. --- End quote --- I know this is a daft question, Rob, but what did you get in Ikea? I searched there site for "Billy phase converter dooda" :bugeye: Ok I didn't :lol: |
| Spurry:
Just make sure there is no mug on top when you switch it on... :thumbup: Pete |
| awemawson:
Nice trolley Rob, and made to your usual stout high quality :thumbup: I am a little puzzled though why you need it. I'd have thought tucking it away somewhere in a dark corner, and putting a three phase socket adjacent to each machine would have been for more ergonomic than trundling the tea trolley about, particularly when alternating between (say) the lathe and milling machine in a typical machining session :scratch: When I was running off a Transwave rotary converter at my last shop I ran a 'three phase ring main' round the room with multiple sockets, and power to the converter was run through the same contactor that operated my 'Emergency Stop' circuit on the 13a sockets. This meant when I'd finished for the day, I just had to press the red button by the exit when I went in for the night knowing everything was isolated except the lighting circuit. |
| RobWilson:
--- Quote from: awemawson on February 12, 2017, 05:48:26 AM --- I am a little puzzled though why you need it. I'd have thought tucking it away somewhere in a dark corner, and putting a three phase socket adjacent to each machine would have been for more ergonomic than trundling the tea trolley about, particularly when alternating between (say) the lathe and milling machine in a typical machining session :scratch: --- End quote --- Hi Andrew, You do have me puzzled :scratch: , really, you thought I was actually going to move the phase converter to each machine! where did I give that impression? HINT Why do I bother :Doh: Rob |
| Navigation |
| Message Index |
| Next page |
| Previous page |