| Gallery, Projects and General > Project Logs |
| Wilson's Workshop Waffle |
| << < (30/74) > >> |
| micktoon:
Looking good Rob ,funny as I looked at the photos I thought the walls were looking grubby next to new cabinets. Is the new Colchester staying in that spot or just there until you get things sorted out for final set up ? You should have a mill for any occasion now by the look of it lol. Cheers Mick |
| Pete W.:
--- Quote from: RobWilson on November 10, 2016, 11:46:31 AM --- Cheers Pete I have ordered a set of 2" vinyl numbers to stick on the boxes , plan label boxes 1 to what ever and have a book with one page per box listing content . The ceiling is 9mm OSB board :thumbup:, the hangers fixings go through the OSB board into the 6x2 ceiling joist ,thats why the shelf end piece protrudes passed the front face of the shelf so I could fix to the joist , did you think it was just fixed to the 9 mm board ? Cheers Rob --- End quote --- Well, no, I was confident it would be secure (you know, the tie-bar right through the ceiling, and the roof, and anchored to a reinforced concrete parabolic arch spanning the entire building!). :lol: :ddb: :lol: :ddb: :lol: :ddb: But then, when that flight of fancy wore off, I looked at your picture again and wondered if your joists run across the building or along it?? :scratch: :scratch: {Sort of apology: I'm being facetious because I've had to sit by the phone all day waiting for an important phone call so I haven't been able to get in to the workshop!! I want to get back to grips with my Delrin!!!!!} |
| Joules:
I had to double read that it was WALLS :lol: |
| millwright:
He has only covered all the walls with cupboards and shelves to save money on the paint!!!!!!!! :lol: John |
| RobWilson:
Evening Lads :wave: Not allot done today ,but I did finish the left hand shelf . All thats left to do is fix the plywood to the steel work :dremel: then I have 6.5 meters of shelf to fill up :) The last of the T2 tool holders arrived this morning , the post man loves me :lol: :lol: I picked up a second T2 Tool post to replace the ye oldie 4 way on the Student Lathe . This way bought lathes can share the same tooling . Cheers Rob |
| Navigation |
| Message Index |
| Next page |
| Previous page |