| The Shop > Composites & Plastics |
| repairing a peli case |
| << < (4/4) |
| angus:
not sure as 2 holes makes me an expert!, i did learn more in filling the smaller 6mm holes (initially left those alone, as if i had struggled with the larger holes the smaller holes were in a position where i could have tapped, and screwed on feet!) with the 6mm holes i counter sunk both sides... filled the outer, and flattened it off with the blade of a knife before it cooled then just did the back i should have countersunk, or bevelled the edges of the larger holes more to give me room for filler the gas iron is a weller, with just a hot air attachment... no hole to take filler... i just did the job similar to what you would gas weld, or braze... dipping the filler (cut off slice of the sheet ) in and melting it in |
| tom osselton:
Ok I thought it may mave been one of this type. |
| angus:
one of those... apparently for unsoldering |
| Navigation |
| Message Index |
| Previous page |