| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (198/202) > >> |
| JHovel:
Thanks for the explanation Benedikt! That was very helpful. Cheers, Joe |
| Benedikt:
I have now fully updated the http://pandora-cnc.eu/ website and the configuration generator at http://config.pandora-cnc.eu/ should now be fully compatible with DDVSV1.1, DDCSV2.1 and DDCSV3.1 running the latest factory firmware. You can download the latest manuals and factory firmware at http://pandora-cnc.eu/download. I would much appreciate if someone could setup a good default starting point for the configurator. I'd be happy to include it as the default set of values. I am also planning to finally complete the translation of the configuration generator to be fully available in other languages. The COVID-19 caused lockdown finally allowed me to do some work on this project again. Stay healthy, wash your hands and wear a mask! Cheers, Benedikt |
| WeldingRod:
Is the current Pandora synced up with DDCSV3? Sent from my SM-G892A using Tapatalk |
| Benedikt:
--- Quote from: WeldingRod on May 12, 2020, 11:15:46 AM ---Is the current Pandora synced up with DDCSV3? --- End quote --- Not yet, but a new version is in the pipeline. Stay tuned! |
| Benedikt:
Many thanks for the kind donation, Rod! :beer: I've now also updated the Windows installer. It will now allow you to easily install the currently latest version of the factory firmware. |
| Navigation |
| Message Index |
| Next page |
| Previous page |