The Shop > CNC
DDCSV1.1 4 Axis controller
hdo27:
--- Quote from: 71taa on July 11, 2018, 12:49:11 PM ---
--- Quote from: hdo27 on July 09, 2018, 03:16:18 AM ---The firmware is dated 2018-06-05.
--- End quote ---
Next build (95) is already available via support forum: http://bbs.ddcnc.com/forum.php?mod=viewthread&tid=43&extra=page%3D1
--- End quote ---
That's great. Thank you.
WeldingRod:
Ifrii,
There is a file that controls the range of values for the machine parameters: eng. I have downloaded this from the machine, edited it, and put it back. This process allowed me to get my steps/mm right. Unfortunately, my issue with low feeds is something else.
Rod
Sent from my SAMSUNG-SM-G891A using Tapatalk
lfriii:
WeldingRod:
I was able to copy the eng. file to a jump drive and edit it using notepad. Copying the file back to the control was a little confusing because, the date shown on the File Page of the control did not change. The time, however did change but only by a few seconds. So it was not clear that the paste worked. But it did work and the control limit has been changed.
Thanks for your help.
lfriii:
WeldingRod:
One other question; copied the update files from Benedikt's website to the jump drive that came with the control. I have since decided not to upgrade the firmware on the control and would like to remove the files to another location and return the jump drive to its original configuration. There are two folders on the drive, install and upgrade and two files, splash.ppm and upgrade.do on the drive that I did not save to it. Do you know if these four items were on the drive when it arrived? Or were these four items downloaded from Benedikt's site?
WeldingRod:
I don't know, sorry.
Sent from my SAMSUNG-SM-G891A using Tapatalk
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version