The Shop > CNC
DDCSV1.1 4 Axis controller
maxx2000:
I did not notice such problems
ryan8:
Does anyone have any ideas as to what may cause an axis to become unresponsive while jogging it, using either the buttons or MPG? I've tried updating to Pandora with the same results.
Sporadically but very frequently, as I jog an axis, it would stop responding to inputs. Interestingly, other axes will still work, until they, too, suddenly become unresponsive. The issue is with the controller and not my drivers, as the DRO stops updating too. Interestingly, pressing reset (and or cutting power and restarting) will have it work again.
I'm wondering if it's some sort of interference or transient issue, although that shouldn't be possible given the optoisolated outputs and inputs.
WeldingRod:
--- Quote from: ryan8 on March 31, 2018, 07:21:37 PM ---Does anyone have any ideas as to what may cause an axis to become unresponsive while jogging it, using either the buttons or MPG? I've tried updating to Pandora with the same results.
Sporadically but very frequently, as I jog an axis, it would stop responding to inputs. Interestingly, other axes will still work, until they, too, suddenly become unresponsive. The issue is with the controller and not my drivers, as the DRO stops updating too. Interestingly, pressing reset (and or cutting power and restarting) will have it work again.
I'm wondering if it's some sort of interference or transient issue, although that shouldn't be possible given the optoisolated outputs and inputs.
--- End quote ---
Ryan,
I've never seen that problem, and I've certainly driven my axies around manually a bunch.
Rod
Sent from my SAMSUNG-SM-G891A using Tapatalk
johnsattuk:
--- Quote from: ryan8 on March 31, 2018, 07:21:37 PM ---I'm wondering if it's some sort of interference or transient issue, although that shouldn't be possible given the optoisolated outputs and inputs.
--- End quote ---
Optoisolaters give galvanic isolation and some degree of filtering, ( depending on their speed ), but they will pass a transient through if it has similar properties to a bona fide signal
Will_D:
--- Quote from: ryan8 on March 31, 2018, 07:21:37 PM ---Does anyone have any ideas as to what may cause an axis to become unresponsive while jogging it, using either the buttons or MPG? I've tried updating to Pandora with the same results.
Sporadically but very frequently, as I jog an axis, it would stop responding to inputs. Interestingly, other axes will still work, until they, too, suddenly become unresponsive. The issue is with the controller and not my drivers, as the DRO stops updating too. Interestingly, pressing reset (and or cutting power and restarting) will have it work again.
I'm wondering if it's some sort of interference or transient issue, although that shouldn't be possible given the optoisolated outputs and inputs.
--- End quote ---
I am starting to suffer this but only on the z axis. It will jog down but not up. Power off and wait resets it.
I am running the [Install_2018-01-21_91] new 2.1 version.
I may well go back to the stable 2017 version for 1.1
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version