| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (177/202) > >> |
| Will_D:
Hi Josef, Thanks for the info. The 3 step probe.nc is actually in most of the 1.1 versions! I eventually found one like yours in the 2017_03-04 version download [Attached]. Not tested this out yet! Trouble is at the moment the 3 attempts version only runs the last probe!! I am still trying to debug this using M00 halts, G04 Pauses and commanding a spindle speed to display a parameter version! NOTE: I don't control my spindle so this is the best way to display variables. Like this: (Safe Block) G17 G21 G90 G54 G40 G49 G80 (set initial X, Y and Z) G00 X0.0 Y0.0 Z0.0 G04 P5000; Little delay (Read the co-ordinates) #20 = #840 #21 = #841 #22 = #842 (Check Settings) (G54.X) S #20*100 G04 P8000; #840 Check Speed! etc M30 % Am getting nowhere at the moment! More later hopefully Will |
| Cosimo.83:
Complimenti per i progressi fatti. Ho notato che se all' interno di un programma provo a richiamare la sonda per fare un azzeramento , esempio la torcia plasma il probe non va , si blocca il programma e rimane in attesa. Forse in autorunning la funzione è disabilitata. |
| Cosimo.83:
Congratulations on the progress made. I tried what is all for a program, for example, plasma is not the case, the program hangs and waits. Perhaps in autorunning the function is disabled. |
| WeldingRod:
Quick question: is the S command in RPM, or percent? Spindle speed... |
| Will_D:
S is in RPM, so if the parameter value is 2.54, times 100 would show a speed on the display as 254. If you really have a spindle then the speed will be approximate depending on the a/d converter in your spindle driver! Cheers Will |
| Navigation |
| Message Index |
| Next page |
| Previous page |