The Shop > CNC
DDCSV1.1 4 Axis controller
<< < (148/202) > >>
johnsattuk:
I think I worked it out,  copied the contents to the Data folder of the origional install ,  all seems to be OK now,  have the new settings showing   :D

Dragon was my Grandaughter's,  she had about 20 various lizards.
ugv:
hello do you know how use probe in sub programme for my tool change?
ugv:
I want measure each tool in auto beetween each tool change with macro
johnsattuk:

--- Quote from: chriscnc on November 09, 2017, 01:47:05 PM ---Ok everyone,

Here is the latest firmware with updated English for the new features and a new motion planning algorithm. This is far smoother and adds line 113 and 123, its now leveraging the FPGA for ARC interpolation, and resolution can now be set to 0.001 on line 123. X,Y,Z can all now have different steps per mm and produce a correct arc. To try this set line 113 to software and line 123 to .001 try some code with line 113 on and off and let me know. The new motion will not stop/pause for transitions from g01 to g03 making a smooth CV like path.

--- End quote ---

Limited testing, but does seem smoother and does allow me to use 300 ppm   :thumbup:
merc:

--- Quote from: chriscnc on November 09, 2017, 01:47:05 PM ---Ok everyone,

Here is the latest firmware with updated English for the new features and a new motion planning algorithm. This is far smoother and adds line 113 and 123, its now leveraging the FPGA for ARC interpolation, and resolution can now be set to 0.001 on line 123. X,Y,Z can all now have different steps per mm and produce a correct arc. To try this set line 113 to software and line 123 to .001 try some code with line 113 on and off and let me know. The new motion will not stop/pause for transitions from g01 to g03 making a smooth CV like path.

--- End quote ---

Hi! I flashed this firmware to my cnc and have a problem with arcs.
Here is short gcode and video:

gcode: https://gist.github.com/arrowcircle/30017c506a6883d7ab227eae4f3af698
video:

Problem is, when it makes second tab it does not stop and goes additional 360 degrees without lifting a tool.

Is this a bug? Or do I doing something wrong?
Navigation
Message Index
Next page
Previous page

Go to full version