The Shop > CNC |
DDCSV1.1 4 Axis controller |
<< < (141/202) > >> |
atomichammer:
Hello everyone. Does anybody know what does this box send to uart with the stock firmware? I thought it would be nice to send current coords in order to display them like pseudo-DRO. |
chriscnc:
Ok in working with the lead engineer of the ddcsv, the arc math for different axis steps has been fixed. here is the new Firmware in the rar attached. Do not change the value below .01mm (see the pic). now The arc interpolation algorithm is set to soft algorithm, set the soft arc algorithm string tolerance setting to 0.01mm (the smaller the higher the accuracy, but smaller then this may cause issues) |
chriscnc:
@ kwood94xj Hi, I don't use INCH but I'm working directly with the factory and lead engineer, can you explain the problem I will add it to the bug list to fix, I have them fixing the homing direction issue now, and they just finished the arc fix on math the new firmware I just posted. |
blades:
Inch mode works on this controller, you just have to mentally replace mm with inch. It would be nice if it were actually switchable between mm and inch, but short of that, it would be nice if the controller referred to "Units" rather than "mm". It would make the controller more universally appealing. I've mentioned the inch thing a few times, but I don't think people are grasping the concept of using it in inches. I've used it like this from day 1. |
Benedikt:
--- Quote from: blades on November 03, 2017, 09:50:16 PM ---Inch mode works on this controller, you just have to mentally replace mm with inch. It would be nice if it were actually switchable between mm and inch, but short of that, it would be nice if the controller referred to "Units" rather than "mm". It would make the controller more universally appealing. I've mentioned the inch thing a few times, but I don't think people are grasping the concept of using it in inches. I've used it like this from day 1. --- End quote --- This may work well for the most part, but if the files contain G20 somewhere the subsequent values will be converted again. |
Navigation |
Message Index |
Next page |
Previous page |