The Shop > CNC
DDCSV1.1 4 Axis controller
tom osselton:
It means your cnc is stuck in Manual!!
:beer:
tom osselton:
--- Quote from: NeoTech on September 15, 2016, 05:47:58 PM ---I have considered one of these prefabbed controllers as well because USB cnc cards is just a effing headache.. I was looking into this one for a plasma table.
http://www.startsh.com/eng/ccx3.html
--- End quote ---
Do you have a torch height controler? I know a guy using these he seems pleased.
http://proma-elektronika.com/index.php/en/products
NeoTech:
No i have not.. I have a Hypertherm PMX85 that i wanna connect up to a Proma or similar tho. Using the CPC connector.. But i have problems getting the damn windows crapstorm software to behave like a plasma cutter instead of a router with trickery.. Thats why i started to consider a dedicated controller instead.
Will_D:
Just searching around for more info!
Found this very informative new you-tube vid:
Note that my s/w version is 2016-05-11-73-NOR and his is even later. (2016-05-19-77-NOR)
NB: Also the English(y) manual that we have is for a 2015-11-18-12
Joules:
Yesterday was design and build a tool sensor to use with the controller.
The body of course is 3D printed :thumbup: a cheap switch with a very repeatable action, in this case it's a keyboard switch. The spring just allows some tolerance so the switch doesn't get crushed if the spindle over shoots.
The real surprise is that this setup is repeatable to 0.01mm every time. Next time I would use a brass sleeve for the moving anvil, as the PLA has just a tad too much friction but may improve over time.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version