| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (126/202) > >> |
| blades:
A thousand thank-yous, Benedikt! :beer: Oh, another question: do you know of any way to take the PWM output of 0-10v and drop it to 0-5v, and still maintain a true PWM variable output? My laser will take 0-5v pwm input. I already had to have it repaired by feeding it from the 0-10v output from the DDCSV1.1 I thought about hooking up a 5v voltage regulator to it, but that would merely clip the upper 5v signal and give undesired results. |
| awemawson:
Simple op amp with feedback ratio set to amplification of 0.5 |
| blades:
--- Quote from: awemawson on July 02, 2017, 01:37:08 AM ---Simple op amp with feedback ratio set to amplification of 0.5 --- End quote --- Sounds like a great idea, I will look into that. Thank you! |
| C6MFG:
Happy to discover the DDCSV1.1 and this forum! I read through all the pages but have not been able to find or missed if there was ever a way to modify it to Imperial/Inches? Is that an option with Pandora? Thanks Jason |
| Benedikt:
--- Quote from: C6MFG on July 06, 2017, 11:27:50 PM ---Happy to discover the DDCSV1.1 and this forum! I read through all the pages but have not been able to find or missed if there was ever a way to modify it to Imperial/Inches? Is that an option with Pandora? Thanks Jason --- End quote --- Hi, Jason! Glad you found it useful. Inches is a very high priority right now. Our rewrite will have inches from the start on, but I am currently working on adding working inches to the original firmware too. So to answer your question, not now but soon. I'll keep you all updated on the progress. Best regards, Benedikt |
| Navigation |
| Message Index |
| Next page |
| Previous page |